SYNOPSYS光学设计软件|ASAP光学设计软件|SOLIDWORKS 三维建模设计软件|RP Fiber Power仿真设计软件|武汉墨光科技有限公司

解决方案

SYNOPSYS™ V16.003 版本更新

The update to version 16.003 incorporates the following changes:

Features:

1. The PAD scan feature has a new flavor. If you hold the right key when you click the button, it will stop at each field point and wait for another click. So now you can examine them all at your leisure. You can exit from this mode by holding the left

2.The variables for Zernike polynomials declared with RSYMM include all axially-symmetric terms. But this sometimes creates a problem when the highest-order term G 36 is varied, since the numbers involved are comparable to the round-off error in some cases. So a new declaration RRSYMM yields a reduced set of variables that does not include this term.

Bugs Fixed:

1.The CCLEAR operand did not work on surfaces declared with a USS shape.

2.The wide-angle object type OBD did not display properly if the object was not in AIR.

3.The command SPL, which saves the PAD layout so you can restore later it with RPL, did not work, since it looked like the obsolete command to save a plot, which was replaced with the save button on the graphics window.

4.The derivative increments for Zernike aspheric terms did not honor the RDR directive, which was supposed to reduce their values.

5.If rays failed when DSEARCH was in the real-ray phase of operation, the final results would show the quick-mode results for that case. This was not intended, and now such cases will not be shown.